Floors, if used correctly can look great at home and can be easily with a little knowledge of DIY, in the form. Here are some tips for installation of wood flooring that should be considered based on my personal experience comfortable with wood floors in my living room. With a little 'of corruption and the right tools you can get good results.
Before the transfer, you must ensure that the area will be done by a reasonable condition and is so thinpossible. The flatter the floor heating, the surface will be better. In between the floors and original hardwood floors, a membrane, which can mask some imperfections, but inflatable areas that appear to be irregular for repair. Your new wood floor will generally be placed lengthwise in the room, because it is the appearance of the area are longer and larger. If the existing floor is floorboards, but instead of concrete, with wood floors is the same waycan lead to irregularities. To overcome this I put plywood making has small screws on flat work surface.
Before laying the wood parts you need to put a membrane usually made of foam rubber or similar found under carpet. What I had bought a silver foil cover. Not only flatten these imperfections, but also acts as a noise damper, and offers very good sound insulation makes the rooms are surprisingly with a wooden floorhot. to completely cover the entire floor area with the membrane before laying the boards. Now you are ready to receive new floor covering, if made with real wood or laminate.
The best way to put it out of the wall furthest from the main entrance to the room, as this can be seen entering the strongest of people. If you can, you can remove all the skirting and architrave in the room, so that the wood floors you can go right into the wall and then replace them later. This has not beenpossible in my house because I did not really have time to remove them and the walls were quite different, as there is an old house was so I just worked up the baseboard and then fixed wood trim around the edge and it was still good.
If it was, always stagger the plates as this is not only good, and replicated the floor on a real wood floor, but adds strength to the surface. Make sure all the pieces tightly interconnected – you can buy a specialadopted and plastic hammer to beat the dishes everywhere, without damaging the edges or links. Leave a space of a few millimeters from the ground and the wool to the manufacturer's instructions – this is because the coating can grow and shrink depending on temperature. For this reason, the decorations of finish are never built, wooden floors, but skirting them.